https://phobos.martem.ee/index.php?action=history&feed=atom&title=Telem-RTC_firmware_upgrade 2026-05-02T17:13:35Z Revision history for this page on the wiki MediaWiki 1.39.3 https://phobos.martem.ee/w/index.php?title=Telem-RTC_firmware_upgrade&diff=775&oldid=prev 2011-12-30T14:34:56Z

<p>Uus lehekülg: &#039;#Erase Flash from the Controller ##Connect power supply to the device ##Switch ER to ON state. ##Wait 5 seconds ##Switch RST to ON state ##Switch ER to OFF state ##Switch PG to O...&#039;</p> <p><b>New page</b></p><div>#Erase Flash from the Controller<br /> ##Connect power supply to the device<br /> ##Switch ER to ON state.<br /> ##Wait 5 seconds<br /> ##Switch RST to ON state<br /> ##Switch ER to OFF state<br /> ##Switch PG to ON state<br /> ##Switch RST to OFF state<br /> ##Wait 10 seconds<br /> ##Switch RST to ON state<br /> ##Switch PG to OFF state<br /> ##Switch RST to OFF state<br /> ##The device is now ready for loading a new frame program<br /> #To Load a New Frame Program<br /> ##Extract Firmware files (Provided by Martem AS) to your computer<br /> ##Install “AT91 In-system Programmer” running “Install AT91-ISP v.13.exe”<br /> ##Specify paths to SAM-BA and bin files in “programmer.bat” file. For instance:<br /> ###echo Setting path to SAM-BA path=&quot;C:\Program Files\ATMEL Corporation\AT91-ISP v1.13\sam-ba v2.9&quot;;%path%<br /> ###echo Setting path to user files path=&quot;D:\Projects\RTU_ARM\RTU-T Firmware\V5&quot;;%path%<br /> ##Specify the COM port. For instance if using COM 5 port: set COMIF=COM5<br /> ##Specify the COM port. For instance if using COM 5 port: set COMIF=COM5<br /> ##Run “gw6_rtc_programming.bat”(Switches ERASE and PROG have to be in OFF state )<br /> ##Wait until loading completing green colored message appears<br /> ##Set default settings by switching.: switch RST ON/OFF state</div>

Roland