IEC101 Objects: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 55: | Line 55: | ||
<td>ENABLE DEBUG - turns ON or OFF sending of software debug parameters</td> | <td>ENABLE DEBUG - turns ON or OFF sending of software debug parameters</td> | ||
<td>OFF</td> | <td>OFF</td> | ||
</tr> | |||
<tr> | |||
<td>2001</td> | |||
<td>CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12</td> | |||
<td>Unknown</td> | |||
</tr> | </tr> | ||
</table> | </table> | ||
Revision as of 09:20, 29 September 2010
For all addresses the GWS parameter "Objects Base Address" is 0.
Setup file for iex.exe can be found from \\Phobos\d\3_Tehniline\3.Seadmed\RTU_T\TELEM-AI12-T Objects.csv(Latest version svn://phobos.martem.ee/RTU-T-AI12/doc/TestObjectsForIecExe.csv)
| Address | Description | Default Value |
|---|---|---|
| 1 ... 12 | Input 1 ... 12 result after zero zone and deadband1 | Unknown |
| 50 | ZERO ZONE ENABLE - turns zero zone calculation ON or OFF | ON |
| 51 | DEADBAND1 ENABLE - turns deadband1 calculation ON or OFF | ON |
| 100 | CAL DATA GI - turns sending of calibration data ON or OFF on GI | OFF |
| 101 ... 112 | CHx OFFSET - Channel x offset, in ADC digits | Unknown |
| 113 ... 124 | CHx REF - Channel x reference, in ADC digits | Unknown |
| 200 | CALIBRATE - Initiate ADC calibration | OFF |
| 201 | CORR ENABLE - turns ON or OFF all calculations of ADC input | ON |
| 1000 | LED RED - turns ON or OFF ALERT LED | OFF |
| 2000 | ENABLE DEBUG - turns ON or OFF sending of software debug parameters | OFF |
| 2001 | CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12 | Unknown |