IEC101 Objects: Difference between revisions

Revision as of 09:24, 29 September 2010

For all addresses the GWS parameter "Objects Base Address" is 0.

Setup file for iex.exe can be found from \\Phobos\d\3_Tehniline\3.Seadmed\RTU_T\TELEM-AI12-T Objects.csv(Latest version svn://phobos.martem.ee/RTU-T-AI12/doc/TestObjectsForIecExe.csv)

Address	Description	Default Value
1 ... 12	Input 1 ... 12 result after zero zone and deadband1	Unknown
50	ZERO ZONE ENABLE - turns zero zone calculation ON or OFF	ON
51	DEADBAND1 ENABLE - turns deadband1 calculation ON or OFF	ON
100	CAL DATA GI - turns sending of calibration data ON or OFF on GI	OFF
101 ... 112	CHx OFFSET - Channel x offset, in ADC digits	Unknown
113 ... 124	CHx REF - Channel x reference, in ADC digits	Unknown
200	CALIBRATE - Initiate ADC calibration	OFF
201	CORR ENABLE - turns ON or OFF all calculations of ADC input	ON
1000	LED RED - turns ON or OFF ALERT LED	OFF
2000	ENABLE DEBUG - turns ON or OFF sending of software debug parameters	OFF
2001	CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12	Unknown
2002	ERROR DEADLINE - counter for task deadlines. If this value increases then TELEM-AI12 is not working correctly	0

@@ Line 60: / Line 60: @@
    <td>CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12</td>
    <td>Unknown</td>
+ </tr>
+ <tr>
+  <td>2002</td>
+  <td>ERROR DEADLINE - counter for task deadlines. If this value increases then TELEM-AI12 is not working correctly</td>
+  <td>0</td>
   </tr>
 </table>