TELEM-GW6 testing manual

Hardware tests

Connect the PC to the Telem GW6 through port 2 RS232, load and writte the Test Configuration Setup "testgw6_3.csv"
1. Z:\Taimar\1.Test\GW6_allports
Connect the cables following this scheme
1. Ethernet to network
2. Port 1-RS422 to Port 5-RS422/485
3. Port 2-RS232 to Port 10
4. Port 3-RS232 to Port 6
5. Port 4 Fiber optic to an external Fibreoptic Modem alredy connected to another device to check the communications.
6. Port 7 to Port 11
7. Port 8 to Port 12
8. Port 9 to Port 13
9. GPS port to an external GPS device.
Check that all the leds are blinking
Open TDC, export IEC objects from Z:\Taimar\1.Test\GW6_allports\objects.csv and check IEC obj. all 7 BI-s must have value 1.(or 0 in IEC.exe)
Make sure u-boot's press any key to stop booting is disabled.
- Use the bootstrapper app.
- If this is not disabled, GW6 will not boot if you send any data to Port2

Change the time in the PC
Go to TDC, GW6 Setup, Common, Time Settings and make sure that the Enable GPS is not click.
Go to TDC, Settings and click on Gen. Int. + Time Sync.
Power ON/OFF (Wait until it restarts)
Open Putty
1. Load saved session "GW6-Timetest" and open (It will log on as martem user automatically, It will give you the time once you have type the password) // if there is no "GW6-Timetest" use IP 10.0.0.144 user: martem and once logged in, enter command: date
2. Password: Xooviet0
The time should macht with the PCs time.//if not(like 1 jan 2000 0:xx:xx), start from 4 again(power on/off)

Go to TDC, GW6 Setup, Common, Time Settings and Enable GPS (Optical). Writte the new configuration on the Device.
Check the GPS green led is blinking.
Power ON/OFF (Wait until it restarts)
1. Load saved session "GW6-Timetest" and open (It will log on as martem user automatically, It will give you the time once you have type the password)
2. Password: Xooviet0
The time now should macht the real time.//if not, ask for date couple of times again, GPS sync might take some time.