GWS Ethernet connection

From Phobos Wiki
Revision as of 07:52, 25 September 2017 by Alfred (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Ethernet connection is used for configuring data concentrators like GW6, GWM, RTA

To establish connection with the device using Ethernet connection, configure settings in SSH window. SSH button opens SSH settings window, where communication parameters can be set. When parameters are set, Test button could be clicked to conform the connection. When Access granted line appears, connection is OK and user can save parameters by cliking OK. Red light next to SSH button should turn green. Connection with the device is established. Now user can read (R) or write (W) configuration from/to device. C is for cancelling.

Parameters in the SSH settings window:

User: Username of the device (default: martem)
IP: IP address of the device (default addresses are for ETH0: 192.168.0.111)
Password: password of the device (default password is provided by Martem AS)
Setup version: GW6-e and GWM support only version 4
Putty: Opens remote terminal
Open Remote Terminal: Opens remote terminal with log in parameters described in User, IP and Password string.
Change password: Enables user to change device password
Test: Test connection between PC and Telem device
OK: Saves the parameters and closes window
Reboot: Reboots the device
R1: Reset the device
R2: Reset and also clear memory buffers
R3: Reset and restore the default setup

Any SSH client, e.g. Putty, can be used to connect with the device. Baudrate 115200bps is used. Necessary user names and passwords are provided by Martem AS.