IEC101 Objects: Difference between revisions

From Phobos Wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 60: Line 60:
   <td>CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12</td>
   <td>CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12</td>
   <td>Unknown</td>
   <td>Unknown</td>
</tr>
<tr>
  <td>2002</td>
  <td>ERROR DEADLINE - counter for task deadlines. If this value increases then TELEM-AI12 is not working correctly</td>
  <td>0</td>
  </tr>
  </tr>
</table>
</table>

Revision as of 09:24, 29 September 2010

For all addresses the GWS parameter "Objects Base Address" is 0.

Setup file for iex.exe can be found from \\Phobos\d\3_Tehniline\3.Seadmed\RTU_T\TELEM-AI12-T Objects.csv(Latest version svn://phobos.martem.ee/RTU-T-AI12/doc/TestObjectsForIecExe.csv)


AddressDescriptionDefault Value
1 ... 12 Input 1 ... 12 result after zero zone and deadband1 Unknown
50 ZERO ZONE ENABLE - turns zero zone calculation ON or OFF ON
51 DEADBAND1 ENABLE - turns deadband1 calculation ON or OFF ON
100 CAL DATA GI - turns sending of calibration data ON or OFF on GI OFF
101 ... 112 CHx OFFSET - Channel x offset, in ADC digits Unknown
113 ... 124 CHx REF - Channel x reference, in ADC digits Unknown
200 CALIBRATE - Initiate ADC calibration OFF
201 CORR ENABLE - turns ON or OFF all calculations of ADC input ON
1000 LED RED - turns ON or OFF ALERT LED OFF
2000 ENABLE DEBUG - turns ON or OFF sending of software debug parameters OFF
2001 CLOCK TEST DI - Value is the state of synchronization selection(1 for internal RTC 0 for external signal), timestamp is the current time of TELEM-AI12 Unknown
2002 ERROR DEADLINE - counter for task deadlines. If this value increases then TELEM-AI12 is not working correctly 0